Where is the filter on a Triton shower?
Where is the filter situated in a Triton electric shower? The filter will be found in the inlet connection. In some units it will be necessary to disconnect from the water supply to access the filter.
How easy is it to fit an electric shower?
The easiest showers to install are models that have top, bottom, side and rear cable and pipe entry points, to make routing them easier. As the cables are often large and inflexible, showers with more space inside the casing and well-designed connection blocks will make life easier for the installer.
Are Triton Showers any good?
We gave it 4.5/5 stars. The Triton Seville Electric Shower is highly rated and popular. We are discussing the 10.5kW model, however, it is also available in 7.5kW, 8.5kW, and 9.5kW, as well. The price on these Triton showers is reasonable that you will enjoy net savings after a short time.
Is it easy to fit a Triton shower?
The Triton Fast Fit or T80Z electric shower is the next generation of the UK’s best selling shower. They feature a high quality design, with great performance. Furthermore they are so easy to install as the unit simply covers the footprint of most electric showers.
Why is water coming out the bottom of my Triton shower?
When I turn on my electric shower water starts leaking out from the bottom of the unit, why? If water is leaking from a clear plastic tube or small plastic elbow in the unit, then the Pressure Relief Device (PRD) has been activated.
Why is there water coming out of the bottom of my shower?
A build-up of pressure can easily cause water to leak from the bottom of your shower. If your shower hose is blocked, this can cause the pressure to increase. When the pressure in the hot water tank gets too high, it activates it, causing water to come out of the valve at the bottom of your shower unit.
How do I increase the pressure in my Triton shower?
How to increase water pressure in the shower
- Clean your shower head.
- Replace the shower head.
- Install a shower pump.
- Installing a pressurised unvented cylinder.
- Install an electric shower with a cold water accumulator tank.
- Install a power shower.
How do I get an airlock out of my electric shower?
Complete an air test!
- Follow these instructions to remove air from your pump installation.
- Turn off pump.
- Remove shower head from hose.
- Let hose hang into bath or shower tray.
- Turn the temperature to full cold.
- Turn the shower on and run for 5 minutes.
- Turn the temperature to full hot and run for a further 5 minutes.
How long does it take to fit an electric shower?
Electric shower: 8 hours for a new installation. 2 hours to replace a shower unit (like for like), once parts have been obtained. From 30 mins to replace a shower switch but typically allow 1 hr.
What do you need to know about Triton t80z?
3.5 A 30mA residual current device (RCD) MUST be installed in all UK electric and pumped shower circuits. This may be part of the consumer unit or a separate unit. 3.6 Switch off immediately at isolating switch if water ceases to flow during use.
How often should a Triton shower be checked?
3.9 As with all electrical appliances it is recommended to have the shower and installation checked at least every two years by a competent electrician to ensure there is no deterioration due to age and usage. Left: Bottom, Back & Top. Right: Bottom & Back. Left: Bottom, Back & Top. *Right: Bottom, Back & Top. (* Z uni-fit kit required.)
Can you use a Triton shower if it is frozen?
WARNING: DO NOT operate shower if frozen, or suspected of being frozen. It must thaw out before using. DO NOT operate the unit if the showerhead or spray hose becomes damaged. DO NOT restrict flow out of shower by placing showerhead in direct contact with your body.