By 4 min read

How do you wire a 3 way Insteon switch?

  1. In Box 1. Step 1: Connect SwitchLinc bare copper wire to ground. Step 2: Connect SwitchLinc white wire to neutral.
  2. In Box 2. Step 1: Connect SwitchLinc bare copper wire to ground. Step 2: Connect SwitchLinc white wire to neutral.
  3. In Box 3 (Load) Step 1: Connect SwitchLinc bare copper wire to ground.

How do you wire an Insteon switch?

Getting Started

  1. Turn off power and connect the corresponding wires from the junction box with the Insteon Wall Switch and cap them with wire nuts.
  2. Install Insteon Wall Switch, attach the wall plate and turn on power.
  3. Follow the on-screen instructions in the Insteon app to add Dimmer Switch.

How do you reset a insteon toggle switch?

Wall Switches & Keypads

  1. Disconnect your Wall Switch or Keypad from power by pulling the set button out.
  2. Press and hold the set button.
  3. Continue holding the set button until the beep stops If your device does not beep, hold the set button for ten seconds.
  4. Release the set button.

How do you program Insteon?

On your Insteon Wall Switch, press and hold the set button until the device beeps. Press and hold the set button again, then tap the set button. Encompassing all on-device programming options, use the local programming to set local properties and factory reset.

How do I unlink my Insteon switch?

To Unlink:

  1. Press and hold the set button on the ‘controller’ until it beeps and the LED starts flashing green.
  2. Release.
  3. Press and hold the set button again until it beeps and the LED starts flashing RED.
  4. On the responder you are now looking to unlink, press and hold the set button for about 3 seconds until it beeps.

Do Insteon switches work with LED bulbs?

Insteon Smart Dimmable LED Light Bulb (A19), Works with Alexa via Insteon Bridge, 8W (60W equivalent) Warm White, Uses Superior Dual-Mesh Wireless Technology for Unbeatable Reliability – Better than Wi-Fi, Zigbee and Z-Wave.

Which wires go on a 3-way switch?

With a three-way switch, three wires connect the pair of switches—two black “traveler” wires and a third “common” wire. When the circuit’s power is turned on, any of these may be “hot,” depending upon how the switches are toggled.

Will Insteon Hub Control X10 devices?

The Insteon hub can control X10 devices, but the Alexa app currently just says that it is unable to control this type of device. Right now the echo-insteon hub interface is pretty minimal – just turning on/off insteon devices.