Why is my airbag light on and blinking?
It could mean that your battery backup is drained, that you have a worn-out airbag clock spring, or that your SRS airbag control module is faulty. It can also mean that something is wrong with your seat belts or impact sensors.
Can I drive with a flashing airbag light?
Is it safe to drive with an SRS light on? It doesn’t necessarily mean that the car isn’t safe to drive but it’s like playing with fire if you do. When this light is on it means your safety system isn’t working at 100% and in some cases, it could mean that your airbags are disabled and will not deploy in an accident.
How do you reset the airbag light on a Ford?
Switch the auto key on the ignition switch. Wait until the warning light on the airbag turns off. Turn your car’s ignition switch back off for just over three seconds. Repeat steps 1 through 3 twice, making a total of three times.
How do I get the airbag light off my dashboard?
How to Reset an Airbag Light
- Put the key into the ignition and turn the switch to the “on” position.
- Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds.
- Repeat Steps 1 and 2 two more times.
Will disconnecting the battery reset the airbag light?
Often, all it takes to get rid of that pesky warning light is to reset your airbag sensor. Remove the terminal clamp and leave it disconnected for 5-10 seconds to allow the airbag sensor to reset. Then reconnect the battery terminal and turn the vehicle on. With a bit of luck, the light will stay off.
Can a blown fuse cause the airbag light to come on?
Blown fuses can definitely cause the airbag light to come on. When the airbag system is malfunctioning, a mechanic or auto parts store should be able to read the code that the system is putting out which will give them a clue as to what particular problem the airbag is having.
Will disconnecting battery reset airbag light?
How much does it cost to fix airbag light?
Number 1 — Reset Airbag Light You’ll need to hire a professional to come in and examine the airbags before you continue to drive the car. This process can take several hours of time and usually costs a few hundred dollars, although depending upon the type of car it may be up to about $600.
How do I turn off the airbag warning light?
How to Turn Off the Airbag Light
- Turn on the ignition switch with your car key.
- Wait for the airbag warning light to turn off.
- Turn the ignition switch of your car back off for a little longer than three seconds.
- Repeat steps 1 through 3 twice to make three times total.
Is there a fuse for the airbag?
What fuse is the airbag fuse? In most models, this is fuse #40, located in the lower right corner of the fuse block. The SRS light is a warning light for your supplemental restraint system (airbags).
Can you sell a car with the airbag light on?
You can sell it, but if someone asks about the airbag light, you should tell them what you know about it.
How does the airbag light code work on a Ford?
These codes are signaled by five flashes, a two-second pause and the number of flashes that corresponds to the second digit.
What does a flashing air bag light mean?
This video will show you how to diagnose and fix a flashing airbag light. The flashing means that there is a fault with the system. You can read the number of flashes and it will give you a code (codes listed below for ford ranger and Mazda B3000).
What does code 13 mean on airbag light?
Code 13 (single flash, pause, three flashes) means that the airbag circuit has shorted to ground and Code 14 (single flash, pause, four flashes) means that the primary crash sensor circuit has shorted to ground.
How do you know if your airbag is working?
Because airbag problems range from a lost battery feed to a shorted circuit, it is important to understand the codes so that the airbag can be properly repaired. These codes are started by a single flash of the indicator light, followed by a two-second pause.