By 4 min read

Is HyperX RAM compatible with HP laptops?

The HyperX will likely work but you gain no performance boost from the “performance” or gaming memory so if it cost more the extra money is wasted. You will do just as well with OEM type memory such as Hynix or Samsung. See p. 42 of the Manual.

How do I get my computer to recognize my RAM?

What to Do If Your RAM Isn’t Detected By Your PC

  1. Step One: Check The Seating.
  2. Step Two: Check Your Motherboard’s Compatibility.
  3. Step Three: Run a Diagnostic like Memtest86.
  4. Step Four: Clean the Electrical Contacts.
  5. Step Five: Test It With Other Systems.

Why is the RAM I installed not working?

Here are the three most likely reasons why your PC won’t work with your new RAM modules: 1 – Your PC/motherboard might not support 8GB RAM sticks and/or it doesn’t support the total amount of RAM that you installed. 2 – The new RAM modules aren’t properly seated in the motherboard’s RAM slots.

Can I put 3200MHz RAM in 2933MHz motherboard?

TL;DR Yes, you can. What’s given is: A motherboard that supports DDR4 speeds up to 3200MHz. A CPU that supports DDR4 speeds up to 2933MHz.

What happens if RAM is not working?

If your RAM is not working properly, then apps won’t run smoothly on your computer. Your operating system will work very slowly. Also, your web browser will become slower. It will take more time to open.

Why are my HyperX Fury Ram sticks not working?

In some cases you may have to enable SPD WRITE for the sticks in the Motherboard BIOS. Same kit, Aura Sync had to be re-installed up to the latest version for them to work. In some cases you may have to enable SPD WRITE for the sticks in the Motherboard BIOS.

Is there a ram issue on a HP laptop?

The motherboard and processor will support 3200 MHz. Therefore, this is not the problem. The only suggestions that I can make are: 1) update the BIOS if an update is available and 2) clear the CMOS. This will clear the BIOS of the old settings.

Why is my HyperX Fury running at 3200 MHz?

I had to call HyperX support after buying and installing the Kingston HyperX fury RGB 3200 MHz 8GB RAM from Amazon. It works, but it will not run at the advertised speed of 3200 MHz and it will not run in dual channel mode. To set the new RAM at the higher frequency, XMP Profile 1 for this memory slot has to be enabled in the bios.

What should I do if my Ram is not working?

The motherboard and processor will support 3200 MHz. Therefore, this is not the problem. The only suggestions that I can make are: 1) update the BIOS if an update is available and 2) clear the CMOS. This will clear the BIOS of the old settings. If these don’t work for you, I suggest that you contact the memory manufacturer’s Tech Support for help.