By 4 min read

How do you code a remote start alarm?

DO NOT remote start the vehicle if it is garaged. To begin the 2 / 3 hour start up timer mode: Turn the vehicle’s ignition ON then OFF. Press and hold the valet button….Operating on the Code Alarm CA4053 Remote Start System.

Function: Beeps / LED Flashes:
Confirm Remote Start 4 Beeps / Flashes (repeats 3 times)

Can I add remote start to my Viper alarm?

Now you can control your vehicle’s locks, security system, remote start system, and trunk release with your cell phone. If you already have a compatible Viper system in your vehicle, you can add the stand-alone Viper SmartStart module.

How Do You Use Code Alarm remote start cat4p?

Transmitter Programming – Feature Bank 1:

  1. Turn the ignition ON.
  2. Press and hold the valet/override button.
  3. Within 10 seconds the system will chirp (3) three times.
  4. Press 1 button of each transmitter you wish to program.
  5. The system will respond with 1 chirp for each accepted transmitter.

How do I turn off my remote start alarm?

How to Turn Off a Remote Car Starter

  1. Press and hold the lock button on your remote while the car is running in auto-start mode.
  2. Wait until the locks on the car repond by flashing. If they do not respond on the first press, press the button again every couple seconds until they respond.

Can I install remote start myself?

Remote starters are convenient, inexpensive and easy to install. Install a remote starter for your car yourself. It’s a great upgrade, inexpensive and a project you can do yourself with simple tools and the supplied wiring diagram.

How do you get code alarm out of valet mode?

To enter or exit valet mode simply follow the 4 steps outlined below: Turn the vehicle’s ignition ON. Push and hold the programming/valet button….To by-pass the alarm system:

  1. Open the vehicle door.
  2. Turn the ignition key to the ON position.
  3. Within 10 seconds, press and release the valet push button switch.

Why does my remote start set off my alarm?

If you factory alarm is being triggered when you remote start your vehicle, it is because your alarm is not being disarmed prior to the engine starting remotely. If you are in a pinch, you can avoid this from happening by pressing the UNLOCK button on your factory remote/fob.