Can Zinsser 123 primer go over oil-based paint?

yes you can, it would still be best to be absolutly clean and LIGHTLY sand before the 123.

Can you put latex primer over oil based primer?

You can paint over an oil-based primer with latex with the proper preparation. If you apply latex paint over an oil-based primer without preparing the surface first, the paint will not stick properly and likely crack or peel.

Does Zinsser 123 stick to oil paint?

Bullseye 123 is pretty decent primer and bonds well to a lot of surfaces including tile… But if you want the best adhesion you should wait about 7 days before painting it. It takes longer to cure on surfaces like tile or oil paint because it can only dry to one side…

What is the best primer to use over oil-based paint?

Allow the surface to dry. Coat it with an oil or latex bonding primer. If the original paint was really shiny, you’ll want to use a primer like Kilz. If it’s not too shiny, you can use a latex primer, then put a couple of latex coats over it.

Can you put water based paint over oil based primer?

When painting over oil based paints, only an oil based paint may be used. The exception is that an oil based primer may accept any kind of top coat paint. For that reason, an oil based primer is recommended to be applied over any oil based top coat, then a water based paint may be used as a top coat.

How long does it take for Zinsser oil based primer to dry?

30 minutes
Because it dries to the touch in 30 minutes, is ready to recoat in 2 hours and sticks to glossy surfaces without sanding, COVER-STAIN saves time on the job.

Can I use water based paint over oil primer?

When painting over oil based paints, only an oil based paint may be used. Otherwise, the paint will peel off or blister off. For that reason, an oil based primer is recommended to be applied over any oil based top coat, then a water based paint may be used as a top coat.

How long does Sherwin Williams oil based primer take to dry?

After priming, allow to dry 4 hours, test a small area for bleeding by applying the topcoat before painting the entire project.